EKey Fingerscan Access Control System Provozní pokyny stáhnout pdf (Strana 38)

General

8.2.3

ELECTRIC CONNECTION

You can find further details such as the

pin configuration

wiring sketches

either on the wiring diagram supplied with the product, or on the DVD (.pdf file).

8.2.4

MOUNTING

You can find further information to be supplied either on the ekey mounting instructions supplied with the

product, or on the DVD (.pdf file).

Other features

Software update

The flawless operation of your ekey home products is essentially guaranteed thanks to the high quality of

the software implemented on the devices. Since ekey is permanently improving its products and providing

them with new features, ekey offers you the possibility of updating your “ekey home” products. That is to

say, you can, as long as ekey makes it available on the homepage, update the software of your ekey

devices (ekey home finger scanner and ekey home control panel) with a software update kit to the latest

available firmware version.

Contact your ekey partner for more details!

10.

Trouble-shooting

Error

display

Cause

Solution

Finger

enrollment

Finger

enrollment is not

working

1. The finger was not swiped evenly over the sensor

starting at the top knuckle.

2. The finger was swiped

with too little or too much

pressure over the sensor.

3. The finger was swiped too fast or too slowly over

the sensor.

4. The finger is being swiped at an incorrect angle.

5. The finger does not have enough features to be

detected (due to wear).

1. Swipe

your finger naturally/evenly over

the sensor without any stops, starting at the

top knuckle.

2. Swipe the finger gently, but not too

carefully over the sensor.

3. Swipe the finger at a medium speed and

at the correct angle over the sensor (see

section 7.2

Fehler! Textmarke nicht

definiert.).

4. Use a different finger.

finger that has

already been

enrolled is no

longer

recognized.

1. During the enrollment, another part of the finger

surface was captured.

2. The recording of the finger was not carried out

properly.

3. The finger was incorrectly swiped over the sensor.

. Re

enroll the fingerprint in the system and

pay attention to swiping your finger evenly.

2. See “Finger enrollment is not working“ –

perfect recording guarantees good

recognition.

3. See section 7.2.

ekey home

nd ekey home

CP WM

The status dot on

the control panel

is not blinking

No power supply

1. Check the power supply, where necessary

check the fuses

Two dots are lit

up on the display

of the control

panel

No or defective device coupling

connect (coupl

e) the devices

(See section 8.2.1.4 Initializing the devices)

Error code

„E0“

on the display,

then the

countdown starts

from 45

1. No b

us connection to the finger

scanner

2. The power supply to the system has been

interrupted. The system will be restarted.

1. Check the 4

core connection cable

between finger scanner and control panel.

Pay special attention to clamp 1 and 2.

2. Check the power supply on clamp 3 and 4,

it must be at least 8V.

3. Wait until the start process has finished.

Error code

„E1“

on the display

99 fingerprints have already been registered

No more fingerprints can be registered.

Where necessary delete existing fingerprints

in order to record new ones.

1 2 ... 33 34 35 36 37 38 39 40 41

Komentáře k této Příručce

Žádné komentáře

EKey Fingerscan Access Control System Provozní pokyny Strana 38

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní kamery EKey Fingerscan Access Control System