EKey Fingerscan Access Control System Provozní pokyny stáhnout pdf (Strana 23)

General

8.2.1.12

RESETTING TO FACTORY SETTINGS

If you carry out this procedure, then all the saved data will be irrecoverably deleted!

If you reset the device to its factory settings, all the user data (user fingers) in the memory are deleted.

The security code is reset to the standard value of 99, the control panel and the finger scanner are

disconnected, and the relay switching times are set for all the relays at 3s.

1.)

First enter the security code as per section 8.2.1.6.

2.)

Press the > button until “rr” is displayed

3.)

Press the OK button

4.)

Enter the left digit of the security code using the < and > buttons

5.)

Press the OK button

6.)

Enter the right digit of the security code using the < and > buttons

7.)

Press the OK button

8.)

After a couple of seconds, “rr” is displayed and then two red dots appear on the display. The LED

on the finger scanner flashes orange. The device is now reset to its factory settings (= as when it

was delivered).

To start operating the device again, proceed from section 8.2.1.4. You must re-initialize the devices.

ENTER SECURITY

CODE

DISPLA Y +

SETTING

KEY STROKE DISPLA Y +

SETTING

KEY STROKE DISPLA Y +

SETTING

KEY STROKE DISPLA Y DISPLAY

SEE B:

Select

MEN

ITEM rr

Security code

DIGIT 1

Security code

DIGIT 2

Your device has now

been reset to its factory

settings!

STA RT

FINISHED

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 40 41

Komentáře k této Příručce

Žádné komentáře

EKey Fingerscan Access Control System Provozní pokyny Strana 23

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní kamery EKey Fingerscan Access Control System